Initiate System Flush and Draw Paint

3:49

6:36

155.1K views

At 3:49 in

Using An Airless Paint Sprayer. Paint Sprayer Instructions. How to use a Titan Sprayer.

Watch on YouTube

What happens here

With the prime/spray valve in the 'prime' position and the pressure control knob set to low, turn on the sprayer. The unit will begin to draw liquid (likely residual water or cleaning solution from prior use, followed by paint). Direct the prime tube into the empty bucket and observe the flow. Allow the system to run until all air bubbles are gone and only a solid, consistent stream of paint comes out. This ensures the entire system is filled with paint and ready.

Goal: Flush out old liquids and fill the system completely with paint, free of air bubbles.

Tools and materials

Empty Bucket — To collect flushed liquid and purged paint
On/Off Switch Titan — To power on the unit
Pressure Control Knob Titan — Set to low pressure for initial purging
Prime Tube Titan — To direct purged liquid into the empty bucket
Titan 440 Impact Airless Sprayer Titan — The main piece of equipment
Paint — To fill the system and spray

What they say

(1,147 characters)

Hide

my paint. Going to power this thing on. You also want to have another empty bucket to run your paint into or the dirty water that's in the thing. So, I got it in the spray position right here. So, the spray position on this machine is up. So, it's horizontal instead of vertical. So, in the up position. Now I'm going to turn my unit on. Flip that switch. I want my pressure down low. Don't have your pressure up high. So I have it in the low position. Then flip it on. So now it's taking in paint. It's starting to suck it up through here. And I can watch it and it'll start it'll start to lower in the gallon of paint as it's sucking it up. So I can start to see the paint lowering. And I'll start running my gun. You can see start running the water now. There's water in the line. In the comments below, right down here, leave your comments and your suggestions what you'd like to see my next video be about. And I'm going to choose it from you, my subscribers. Just going to keep running it till I see paint coming through here. Now I got my paint coming through and now it's ready to spray. I'll just turn my pressure up, put my tip and guard

Auto-generated from the video audio.