Prepare Fireplace for Installation

i have a good feeling about this installation works the same way like i said across concrete brick studs in the wall you'll need rebar uh three bucks a piece home depot we're gonna create a hole this is half inch we're gonna take our half inch drill bit mark out i know where my studs are so this is why i kept drawing and all this stuff find out where your studs are on the wall we're going to drill a hole keeping this as level as we can then we're going to take some five-minute epoxy pour it on it start hammering it in place and then tomorrow when it dries we'll cut off the ends and then make the matching marking on the beam so we could slide it on and i'll show you the key how to secure it after that i might need to make them a little bit wider [Music] okay mix up our five-minute epoxy let's splurge okay we gotta mix this for 20 seconds [Music] 25 look at that we even went above and beyond [Music] [Applause] now i know it says five minute epoxy so it technically should start drying in five minutes uh i'm gonna be safe since the urethane varnish is drying we might as well let this dry overnight and then just be ultra safe but dang that's pretty dang leveled huh a few moments later look how beautiful