Skip to main content
Stesso

Install Cross-Supports and Climbing Sections

3:30
24:50
128.5K views

At 3:30 in

The Most Dangerous Playground I've Ever Built

Watch on YouTube

What happens here

To address the miscut base piece, the creator cuts additional support pieces. He decides to use a single 45-degree angle cut for ease of installation, even if it doesn't perfectly align with the complex angles of the existing structure. These smaller pieces are then screwed in between the main vertical posts, creating a ladder-like climbing section on one side and a solid wall on the other. He cuts the horizontal slats using a miter saw for precision.

Goal: Add horizontal supports to create climbing surfaces and stabilize the pyramid.

Tools and materials

  • 2x4 Lumber — Horizontal supports for climbing surfaces
  • Impact Driver Ryobi — Securing the horizontal slats
  • Miter Saw Ryobi — Cutting horizontal slats for the climbing sections
  • Screws — Fastening lumber

What they say

Hide

the angle is and cut it and we'll attach it this way I'm done with triter I'm done with try to be smart okay I'm just gonna be done folks I am way too stupid to do this level of math I have two angles I have to deal with this and that can do it didn't do that well in school instead I'm just gonna stick to one angle 145 degree it's going to go in nice I'm not gonna have any issues it's just not gonna flow with this angle lots of angles I kind of want to put like a tire swing down below here nice and low you know so like you just hit your head against all this stuff and get a nice nicely well concussed so you don't have to get that in sports [Music] part right here is going to be the rock climbing section you know you grab and pull yourself up I cannot for the life of me figure out how to make these angles because I'm not that good like I already mentioned so I think what I'm going to do is I'm going to screw right through the middle of this 4x4 and then have them overlap and then to make it look pretty when it's overlapping I will take a chalk line and my tracksaw and create a nice clean cut so we'll follow the profile it's nice to know that there's a solution for something might not be the best but it's a solution

Auto-generated from the video audio.