Assemble Leg Structures and Supports

two two by fours 30 inches in length that gives it four inches overhang now here's the fun part that's really going to make this thing pop we're going to continue this radius story to here so this is all going to blend together we're going to get this thing looking super good we're going to create a four inch hole in the middle of this i'll use it by drawing out the rectangle taking a drill bit drilling a hole in each of the four corners and then using my jigsaw to cut it out and basically just use it as a template so now as you're cleaning up this cut that you made you can now have a good solid template that you go okay well this part's a little too tight so once we just clean up that area before we break any boards uh jigs i guess we can call this a jig [Music] all right so this is the beam exhibit a beam we're gonna cut out all this tenon here it's gonna fit in our slot that we made off of this little example i'm also gonna create a hole on the outskirts of that and that is where that wedge is gonna go through that tenon the cutting i'll be easy jigsaw out of the clamps we're going to use the same radius all around there we go here are our legs the base of the legs and the legs we only need two of those right i just passed out and created two too many i feel like i need to not work so much threw some clamps on it and uh i'll see you guys in the morning all right it's the next