Install Trim Plate and Handles

going to slide perfectly in place. Okay? Want to take this Delta trim plate. This is going to right there. There's one. Okay. There we go. There's two. That was a pain in my bum. I don't like to over tighten these, so I just use a screwdriver. This happens to be an 11-in-1. Around the backside of this plate is a gasket much like this one. I am still going to put some clear caulk around this. There's a little divot hole that maybe you could see leaking like kind of like this one right here, and I won't caulk that, but I'll caulk everything else around it. It's on. Okay. This piece, like so. It'd be for hotter or colder. I think you This is like your limit. So, I think you roll it back. I think this is as good as that will roll. Okay. So, let's try that. See if that is what we can do here. Screw this in. This honestly was just a little bit confusing to me of how this goes in place, and I'm pretty sure this is it. Does not want you to over tighten it. Once we get it to a good stop point, I think that's where I can go there. On off. Colder, hotter. Get it adjusted. Right, this will go pretty far. It'll just where you want it. This piece right here. It just actually clips on the couple of tabs you can see tabs right there. I just start on this handle side. Go right there on that side. That's secure. This will give you more hot water. Get that where you want. That'll give you colder. That's going to be cold. But now, you set this to where you like. Well, then all you got to do is turn it on. And you never have to touch this again and you're going to get that perfect temperature every time. So,