Skip to main content
Stesso

Restore Water Supply and Reset Indicator

0:49
1:07
3K views

At 0:49 in

Quick & Easy T3 RO Water Filter Replacement! #waterfiltration #water #diy

Watch on YouTube

What happens here

After installing the new filter, slowly turn the dedicated water shutoff valve for the RO system back to the on position. Once water flow is restored, navigate to the control panel of the Waterdrop system. Press and hold the 'CF' button for approximately 7 seconds until the red light extinguishes and the system emits a beep. This action indicates that the filter change has been successfully registered, and the internal filter life counter has been reset.

Goal: Re-enable water flow to the system and reset the filter life indicator.

Tools and materials

  • Shutoff Valve — To restore water flow to the RO system

What they say

Hide

underneath my sink. Don't mind our dishes. That shut the water off, grab that CF, turn it to the left, it's going to release it, boom. You want to make sure that that the labeling faces the front. We'll turn our water back on slowly. Hold this down for 7 seconds. We're going to let that run right there for 15 minutes and we're going to be good to rock and roll. And if you forget all those steps, they're right there on the filter. If you want to check out a full installation video,

Auto-generated from the video audio.