Adjust Roller Pins to Prevent Drag

7:45

9:31

1.9K views

At 7:45 in

Proper Use | Expert Lumber Staining Machine

Watch on YouTube

What happens here

Inspect the foam rollers on the machine. Each roller is mounted on a sleeve that slides onto a central pin, secured by keepers. A common issue is when the keepers are pushed too far in, causing the sleeve to rest directly on the end of the pin. This creates unwanted friction and drag, preventing the foam roller from spinning freely as lumber passes through, which can lead to tearing of the roller. To correct this, adjust the keepers so that approximately a quarter-inch of the central pin is exposed. This small gap allows the sleeve and roller to spin effortlessly, ensuring smooth operation and longevity of the rollers.

Goal: Ensure the roller pins are correctly exposed to allow the foam rollers to spin freely, minimizing friction and preventing damage.

Tools and materials

Expert Lumber Staining Machine

What they say

(1,473 characters)

Hide

machine is level right got another tip that I want to you know show you it's with these um rollers right here so the rollers on the outside I'm going to show you little trick and this was an issue you know I ran into the roller knot spin you know freely and causing a lot of drag when the picket or the uh Lumber was going through and it was actually tearing up the roller itself this the the foam roller and that is how this thing is actually attached it's so you got a pin center pin that goes through and then this thing the foam roller is on a sleeve right here right there just like that so it slides on this sleeve it's going to go down this is what holds it in place in order for this thing to spin freely inside the sleeve and have your foam roller spin freely the keepers that are attached to this sleeve have to have a certain portion exposed right here so I got about A4 of an inch exposed now it wasn't exposed and the keeper was sitting down there and the sleeve was actually inside when you slide this on the sleeve is going to be riding on uh the end of your pen right here it's going to cause drag and friction and what I noticed is it doesn't spin as freely because of the drag you know on that keeper right there so I want to make sure this thing is sitting up about A4 of an inch now there's going to be less drag sitting on the end of that right there and it's going to spin a lot Freer and it's going to be a lot easier and you're not going to D roller

Auto-generated from the video audio.