Apply Teflon Tape to Threads

What happens here

To correctly apply Teflon tape, first, insert your index finger into the center of the tape roll and run the loose end of the tape over your middle finger. Position the pipe's threaded end on top of the tape, making sure to start the tape one or two threads in from the very end of the pipe. Crucially, wrap the tape in a clockwise direction around the threads. This ensures that the tape tightens onto the threads rather than unwrapping when the pipe is screwed into a fitting. Apply approximately 3 to 5 wraps of tape, ensuring each wrap overlaps the previous one slightly to create an even layer. Once sufficient wraps are applied, gently pull and break the tape to separate it from the roll. After breaking off the tape, use your fingernail or finger to lightly press and mold the tape into the first thread to secure it.

Goal: Properly wrap Teflon tape onto the pipe threads for a tight seal