Apply Paint with Power Roller

let's just stick this in the bucket now I can see there's paint coming out Oh get this right over into our bucket we'll run it just a little bit more to make sure it's all paint you want to be very careful not to spray it all over the place just lightly pull the trigger now we got paint running out of there now I'm just gonna attach my roller all right McKenna so now we've got to our masking paper down got a floor protected we're gonna load this thing up I can load it up on the ceiling where I can load it up on the wall we're gonna be repainting our walls so we just load it up right here so I'm just to start pulling the trigger and you'll start to see paint starting to come out and I've just got to work it on the NAP till it gets completely loaded now I'll put it on the ceiling so I load it up now we're all loaded up it's all loaded up now you just start rolling along and all you do is when you need paint when you feel like the roller is getting dry you just squeeze the trigger so you don't continuously you don't continuously it's only when you need the paint so I'm just I'd squeeze the trigger once right there and now I just rolled it and you know you can go about so I just squeezed it twice to cover this area right here is there a certain direction usually so there is this you know it's ideally we're gonna want to work you know from we got the light coming in this direction so I'm going to want to work the ceilings are painted really well from that was one thing these painters did before they coded them really well so I don't think we're gonna have a flashing issue I think what we'll do is we'll work you know this direction on the ceiling so we're gonna just work our way down the wall this way so you know we'll work over here if I'm up against the ceiling here you can see how the NAP will hit the ceiling so I turn it in this direction and you just work in a small block like this now just go back over it and you don't you're just putting just a little bit of pressure now just work down here again push to get myself some paint onto the roller and then once you get a section you do what we do called laying it out just like this we'll lay this out this section now I'm gonna move on to do two more this whole section right here so you're gonna go over here put your roller up onto the ceiling now start to roll and squeeze the trigger put some paint on the roller there you go this is hard now pull the trigger put some get some paint on it so instead of you know…