Mounting the Feeder Hopper

equipment so the next thing we're gonna install is the hopper this is the hopper you see these two bolts they go there okay this is your new best friend and he goes inside like that okay so he's gonna go through there inside like that now you see this it's a little bit bent right here it may be a tight fit if it's a tight fit we may have to take a rubber hammer and knock that back out so first of all I got to pick it up it's probably gonna weigh somewhere neighborhood of 80 pounds or so so it's gonna be fairly heavy and cumbersome what you need to do is take this bolt go through there start that and then this bolt and go through there and start that okay so both bolts and nuts need to be in your hands alright the bolt goes through then the washer then the nut okay cool it's probably 120 pounds not really worried about scratching things as much as we're worried about me dropping it or hurting my back cool okay in case you guys are doing this on your own there is a tab right here that you can hang this off of the bucket on your tracker but I've got the help of mrs. Stoney Ridge here so I think will be just fine okay ready go another way no whoo all right so we got everything all tightened up this is the wood chipper fully assemble we have a PTO shaft we've got to put on it then we get the tractor backed up here get this thing fired up I'm excited hope you guys aren't too neutral Killswitch in contact nice Gudrun attractor right here 836 hours I'm gonna say it's 35 years old nice tractor we're gonna be putting it to the test today though