Clean and Remove the Reusable Floor

set this aside now if you're working and you're going to save your floor then you're not going to reuse your liner if you're going to reuse your liner uh then you wouldn't want to do the method that i do to take the floor out because i just cut the plastic right here fold it up so it has plastic still on the opposite side of the floor so i'm going to vacuum my floor up because i'm going to reuse this thing now i do like just cutting out reusing this board floor just folds up and it just makes setting up the spray booth a little bit faster a little bit easier in the export itself when it's rolled up it's kind of wants to keep its shape and once it's flattened out it stays flat i store the floor flat so i'm going to cut this thing the floor out right now and then begin pulling the rest of the booth apart all right i'm going to begin removing the floor and once again the floor itself if you're going to reuse the booth if you tape your floor down to the booth itself then you're gonna have to cut it off this floor was reused many times so i just unfolded it set it inside here didn't have to tape it down but if you tape it down to the plastic you would have to cut it free from the plastic and then once again the booth is not reusable and i do always put down a paper floor just because of the overspray falling down on the ground paper has a tendency to absorb it and not have a wet over spray that you're stepping in the plastic uh doesn't absorb the water or you know whatever materials in the coating doesn't absorb it dry it out fast and you could end up be stepping in wet over spray so if it's stuck down here i'm gonna have to just take a knife and cut it but my floor itself it looks like it's um the tape is not attached you can see i just fold this up and i carefully fold it i'm going to lay down slowly because there's obviously dust on it and i don't want to kick up a lot of dust but you can see the plastic on the bottom of the floor from the previous booth right here but there's my booth floor and i actually just store this right here at my shop and i reuse that floor so when i get my boots set up i just unfold that lay it out and i've got a new floor and i don't have to go to the extent of rolling a floor out i'm taping it down and once again because when you're rolling it out it wants to keep that rolled up shape it takes a while for it to settle down and lay down so now if you're going to be reusing your booth you're going to have to start this step of…