Skip to main content
Stesso

Cut and Layout Plates

0:00
2:37
2.6M views

At 0:00 in

Learn framing fast 👍 hope this helps #learn #framing #carpentry #rafters

Watch on YouTube

What happens here

Begin by cutting three plates for your wall frame: a bottom plate, a top plate, and a double top plate. The instructor demonstrates using a speed square to mark a 3 1/2 inch overlap for the studs on the outside corner of one of the plates. The remaining plates are then aligned for marking. Next, measure from the outside corner to find the center layout (e.g., 16 inches on center). Mark 3/4 inch on each side of the center mark to indicate the stud placement. The instructor recommends three nails for strength, especially if a rafter will sit on it.

Goal: Prepare and mark the wall plates for stud placement

Tools and materials

  • Miter Saw — Cutting the wood planks to length
  • Pencil — Marking measurements on the wood
  • Speed Square — Ensuring accurate 90-degree markings and measuring for stud layout
  • Tape Measure — Measuring plate lengths and stud spacing
  • Wood Planks — Creating the bottom, top, and double top plates

What they say

Hide

Cut three plates, your bottom, and your double top. One plate on each end will have a 3 and 1/2 in overlap. Measure layout from outside corner, not the inside. So, we overlap our furthest plate 3 and 1/2. Line the other plates up and pull it to center layout. Now, we mark 3/4 on each side. You don't have to do three, but if your rafter sits on here, it does help. Then, you'll mark and cut your studs. A two-stud or insulated corner gets

Auto-generated from the video audio.