Apply Paint to Baseboards with Three-Pass Method

them in one shot. Now, I always shoot at a 45°ree angle. So, I hit the top of the baseboard. Then I hit the face. And I hit the face at two passes on the first coat. And you'll see what it looks like. The two passes. And you can do um logical starts and stops. This is really short. It's simple. So, logical start and stop is just here. But this uh room, logical start stop is from here to all the way over there. On the baseboards, I I'm not as particular about logical start and stops because I'm shooting three times. So, if I did the top, I'd do all the way around, work my way around the top, and then by the time I come over here, it could start flash drying and cause it to be rough. And so, I work, you know, in sections and do my three passes and move around the room. Where you have overlaps, you're more likely to have runs. And so, um, if you're uncomfortable with your spray technique and you're getting runs, then working all the way around the room and not having over overlaps is, um, pretty ideal. Now, when I do a door jam, it's very replicatable. I do it exactly the same every time. I do baseboards exactly the same every time using two different techniques, and that's um, logical start and stops or just working around the room. I found that even with a 510 tip, you know, one pass wasn't hitting it well enough. So, I was doing, you know, two passes and then moving forward. So, let's take a look and see what it looks like here. So, it's look like this. I'm going to shoot the top and then I'm going to shoot the face and come back. So, that was two passes right there. So, this is what it looks like. Top, face, bottom. Just like that. So it's top face bottom top face bottom. So that will actually create a spit every, you know, start and stop. So I'll show you what it looks like. If you're really concerned about a spit or you're you want to do logical start and stops, it's going to look like this.