Skip to main content
Stesso

Quick Core Ejection

0:01
1:07
2.7K views

At 0:01 in

Finally, a hole saw that doesn't get stuck! #tools #diy #hacks

Watch on YouTube

What happens here

The most common complaint with hole saws is the difficulty of removing the core material after a cut. With the Spyder Quick Eject Arbor System, this process is simplified. After completing a hole, simply press the blue button located on the arbor. This action causes the hole saw cup to slide down the pilot bit, fully exposing the cut material. You can then easily grab and remove the core by hand or by tapping it out, allowing you to immediately resume cutting without any delays for prying out stuck material.

Goal: Efficiently remove cut material cores from the hole saw.

Tools and materials

  • Cordless Drill Milwaukee — Powering the hole saw for drilling
  • Spyder Quick Eject Arbor System Spyder — The primary tool for making holes and ejecting cores
  • Workpiece — The material being drilled into (e.g., wood, MDF)

What they say

Hide

At the end of the day, any hole saw is going to make a hole. But, the number one complaint most of you guys have with using hole saws is after you make your hole, you're going to have to dig out that core with something. So, with the Spyder Quick Eject Arbor System, you just press this button, and the whole cup will slide down on the pilot, easily exposes that material, quickly remove it, and go straight back to cutting. As you can see, our pilot is a lot longer. Um so, that's going to allow you to to make angle cuts a lot easier. You know,

Auto-generated from the video audio.