Skip to main content
Stesso

Dry Fit Components

0:22
1:01
19.9K views

At 0:22 in

Does Your Toilet Flange Sit Too Low? #oatey #helpingothers #diy #plumbing

Watch on YouTube

What happens here

Perform a dry fit by placing the yellow flange extender into the existing drain pipe. Check if any of the red spacer rings are necessary to achieve the desired height, which should be about a quarter-inch above the finished floor. In this case, no additional spacers were needed.

Goal: Determine Required Height

Tools and materials

  • Flange Extender Oatey Set-Rite — Raising the flange height, Spacer Rings Oatey Set-Rite used for Adjusting the flange height

What they say

Hide

everywhere and we need to raise this up a quarter inch above the finish floor. Phone gasket, that's what's going to go down on top of the flange, flange that sets down inside it. It comes with some big old stainless steel screws and a bunch of different other extension pieces. I get that fits in there really well. Don't need a space here right now. This bad boy set around right here. That is way better than what it was. I don't like using these little cheap washers right here. I always just use an extra set of nuts and washers. These are self tapping screws and it's

Auto-generated from the video audio.