Wire the Charger

0:49

1:23

32.2K views

At 0:49 in

Day in the Life of a Resi Electrician⚡️ Installing a Home EV Charger, would you get an EV?

Watch on YouTube

What happens here

With the charger base mounted, the electrician proceeds to terminate the 8-2 Romex wire inside the Tesla Wall Connector. This involves stripping the insulation from the wire ends and connecting the two hot conductors and the ground wire to their designated terminals within the charger. The neutral wire from the Romex cable is not used for this 240-volt EV charger and is instead safely capped off. Each connection is torqued to the manufacturer's specified setting to ensure a secure and reliable electrical contact.

Goal: Connect the electrical wiring to the Tesla Wall Connector.

Tools and materials

8-2 Romex Wire Unspecified — The electrical cable being connected to the charger
Electrical Tape Unspecified — Taping the unused neutral wire black to signify its non-neutral function in a 240V circuit
Insulated Gloves Unspecified — Protection against electrical shock during wiring (if power cannot be completely cut to the panel)
Screwdriver — Securing wire terminals to the specified torque
Wire Nuts/Connectors Unspecified — Safely capping off the unused neutral wire
Wire Strippers Unspecified — Removing insulation from the ends of the electrical wires

What they say

(541 characters)

Hide

between a 15 amp breaker to a 60 amp breaker. But after we did a panel load calculation, we were able to only install a 30 amp breaker due to load and safety. I'm torquing my conductors, two hot wires and one ground wire. I taped the neutral wire black because this is a 240 volt EV charger. No neutrals needed. I put my heart out on because it was getting extremely sunny out and I didn't have a hat. So, I can't go wrong with more safety protection and PPE. And boom, we just finished. So, here's a recap. We installed a 30 amp double pole

Auto-generated from the video audio.