Skip to main content

Cut Outside Corner Pieces

0:40
1:10
14.2K views

At 0:40 in

Cutting crown with single bevel saws

What happens here

To cut the right piece of an outside corner, place the crown molding on the right side of the miter saw's fence, with the ceiling-facing edge against the fence. Set the miter angle to the right and the bevel angle to the left. For the corresponding left piece of the outside corner, flip the crown molding upside down (so the wall-facing edge is now against the fence) and place it on the left side of the saw's fence. Keep the miter angle set to the left and the bevel to the left. The rule 'inside opposite, outside the same' implies that for outside corners, the molding piece's orientation (left/right piece) is the same as the saw's miter direction.

Goal: Create two pieces of crown molding that form an outside corner.

Tools and materials

  • Crown Molding — The material being cut into outside corner pieces
  • Miter Saw — Cutting the crown molding to create accurate outside corner angles

What they say

Hide

this direction, we need to cut our right side. So, all we're going to do is just flip it upside down. That's an inside corner. Outside corner, we're going to put our right piece on our right fence. Our miter is going to go to the right side, so we can cut this one normally. Since we can't bevel this way, we're just going to flip our left side piece. Get them where you want them, nail them up. Get it where you want it. Just like that. Outside corner.

Auto-generated from the video audio.