Removing Overspray from Porous Brick

9:00

11:40

27.7K views

At 9:00 in

Airless Spraying Tips and Tricks | YOUR QUESTIONS ANSWERED!

Watch on YouTube

What happens here

If you get overspray on porous brick, the most effective approach is to address it as quickly as possible while the paint is still wet. For oil-based overspray on porous brick, white vinegar has been known to work in some cases. For latex-based overspray, you might need to use products like ammonia or 'Goof Off'. When scrubbing, it's generally safer to use a nylon brush. Be cautious with wire brushes, especially when using certain chemicals, as they can cause the brick to stain gray. The goal is to irrigate the brick with the cleaning solution and remove as much paint as possible before it dries and sets deep into the porous surface. Once dry, removal becomes significantly harder.

Goal: For overspray on porous brick, address it immediately while wet. For oil-based paint, white vinegar may work. For latex, try ammonia or 'Goof Off'. Use a nylon brush to scrub, avoiding wire brushes with some chemicals to prevent brick staining.

Tools and materials

Nylon Brush
Wire Brush
Ammonia
Goof Off
White Vinegar

What they say

(1,588 characters)

Hide

oh this person got overspray on porous brick due to a lack of better masking any suggestions on removing it if I can remember what we did I would tell you so Laurel had it yes that was vinegar floor that's right like spray cans it was been an oil-based and it actually worked yeah vinegar it was a white vinegar we use now if you're talking like a latex based thing and you got overspray all over it you're probably looking at you know using ammonia or goof-off or something like that to try to remove the coating from the brick and a wire brush you're trying to get in there but it depends how porous brick is and yeah be careful to like wire brush you know it's because sometimes some of the chemicals the wire brush will start to stain the brick and graze so if that was the case you can use a nylon brush you know and just what you start ended up running into unfortunately as you start to clean the brick really good so then it's not clean and you start to see a difference where you scrubbed and cleaned versus not cleaned and you know just don't get overspray on the track and then it won't have that problem try to remedy do you're gonna try to fix it right away if you if you see that it happened you should be pulling the masking which see wasn't the case here you should you know whatever move the masking away and try to clean it while it's all wet you're more likely to ear engage that brick and get water after there and get as much of that pain out as possible versus if you let it dry then you're gonna have a harder time fixing this problem so is that like irrigating the

Auto-generated from the video audio.