Masking and Painting Side Door

All right. Now, I've got this door sprayed. Going to get over here, start masking. Going to spray this door. Don't forget, if you haven't subscribed to our channel, hit the subscribe button. Also, hit the notification bell. If you don't hit the notification bell, you'll never get notified every time I come out with a new video. It's simple, free, easy to do. It doesn't cost you anything. Just click, click, subscribe, notification bell. Now, let's get over here, mask this door, and get this door sprayed. [Music] All right, now we're on to the side of the house. I'm going to spray this door. I've got a light here. I'll remove this light, too, at the same time. I don't want to get any overspray on the light. When I was doing lights, numbers and downspouts, I didn't even see this light. So, I'll remove this guy and then mask this door off. Spray the door. And this is like if I'm um working as a crew, like a threeman crew or so, the the body, this is the same color as the body. We're going to do it all at the same time. But when I'm working by myself, I'm going to tackle like small things at a time. Like I'm going to just tackle all the doors. And then when I come back and spray the body, I'm just going to spray this, open this door, and just shield and spray around it so I don't get any overspray on the newly sprayed door. But I won't have to come and do as much masking when I spray the body because this will already be masked off and sprayed. So going to um remove this light. Now, this should be an easier one than the other lights. We'll see. Good idea to check to make sure your power's not on. You get zapoed. going to take and just once again this is a light unlike all the rest of the lights. so we know exactly where it goes. Just going to tape my nut on there so it doesn't get lost. Set that aside right there. Now I'm going to begin masking this door. I'm going to be using frog tape to frog tape production tape to mask the door knob off. And then um we're going to be masking the inside. We don't want any because we removed the weather strips. going to want any overspray on this or these two edge of the door. We're only spraying the face of the door. So, I'll show you what that looks like. I'm going to run just inch and a half. This is inch and a half tape. Don't want anything overspray inside here onto the hinges. And one one row of inch and a half is all you need. Going to put a row on the inside edge of this door, which this is the inside color of the…