Unpack your new faucet. If it comes with a base gasket, place it over the faucet holes. If not, apply a 1/4-inch rope of plumber's putty to the underside of the faucet base. Carefully feed the faucet's tailpieces and any attached hoses down through the correct holes in the sink deck. From underneath the sink, slide on any supplied washers and thread the mounting nuts onto the tailpieces. Hand-tighten them to hold the faucet in place. Install the side sprayer base in its hole, feed the hose through, and secure it with its nut from below.
You're viewing a step from: How to Replace a Two-Handle Kitchen Faucet
This project involves the complete removal of an old two-handle kitchen faucet and the full installation of a new one. The process begins with shutting off the water supply, disconnecting the old hardware, cleaning the sink deck, mounting the new faucet, connecting the new water lines, and finally, testing for leaks and proper operation.
Frequently Asked Questions
Do I really need a special basin wrench, or can I just use a regular adjustable wrench for this project?
While an adjustable wrench is useful for visible connections, a basin wrench (like the TEKTON or Husky models listed) is highly recommended. Its long, telescoping handle and pivoting jaw allow you to reach and loosen nuts in tight, awkward spaces under the sink that a standard wrench cannot access. This tool significantly simplifies the removal and installation process.
What are the most important safety precautions to take when replacing a kitchen faucet?
The most crucial step is to completely shut off the hot and cold water supply lines to your sink before starting any work. Ensure you have a bucket and towels handy to catch any residual water, and use proper lighting (like the listed flashlight) to see clearly in the confined under-sink area. Never try to force connections without proper alignment, as this can cause damage.
The project is rated "beginner." Is it truly manageable for someone with no plumbing experience?
Yes, this project is beginner-friendly because it primarily involves disconnecting and reconnecting parts, not complex pipe cutting or soldering. The most challenging aspect is often working in confined spaces under the sink. Take your time, follow the instructions carefully, and ensure all connections are hand-tightened before a final wrench turn to avoid cross-threading.
What should I do if I can't get the old faucet nuts or supply lines to loosen?
Old nuts can be stubborn due to corrosion or mineral buildup. First, try applying penetrating oil and letting it sit for a few minutes before using your basin wrench for leverage. If still stuck, a hacksaw or oscillating tool might be necessary to carefully cut the old nuts or lines, but proceed with extreme caution to avoid damaging the sink or existing plumbing.
How to Replace a Two-Handle Kitchen Faucet
View Full ProjectRelated Videos
Step 1: Prepare Workspace and Shut Off Water
Step 1: Prepare Workspace and Shut Off Water
Step 1: Prepare Workspace and Shut Off Water
Step 2: Disconnect Water Supply Lines
Step 2: Disconnect Water Supply Lines
Step 2: Disconnect Water Supply Lines
Step 3: Remove the Old Faucet
Step 3: Remove the Old Faucet
Step 3: Remove the Old Faucet
Step 4: Clean the Sink Surface
Step 4: Clean the Sink Surface
Step 4: Clean the Sink Surface
Step 5: Mount the New Faucet
Step 5: Mount the New Faucet
Step 5: Mount the New Faucet
Step 6: Connect Water Supply and Sprayer Lines
Step 6: Connect Water Supply and Sprayer Lines
Step 6: Connect Water Supply and Sprayer Lines
Step 7: Turn on Water and Check for Leaks
Step 7: Turn on Water and Check for Leaks
Step 7: Turn on Water and Check for Leaks
Start your project
chat with your ai