Skip to main content
Stesso

Assess Wiring and Prepare Meter

0:00
1:28
729.6K views

At 0:00 in

Tip when Installing Utility Meters #hendythesparky #electrician

Watch on YouTube

What happens here

Before any installation, the existing service wiring within the meter socket should be thoroughly inspected for damage or wear. The electrician points out an older wire jacket that had started to peel and explains that he had previously applied duct tape as a temporary measure to contain it. He explicitly states that this is not a permanent solution and should be properly replaced, which was not possible in this scenario due to inaccessibility from the basement. This step underscores the importance of assessing the condition of all components.

Goal: Ensure existing wiring is safe and the meter is ready for installation.

Tools and materials

  • Duct Tape — Temporarily reinforcing peeling wire jacket (as a non-standard, temporary measure shown in the video)
  • Electrical Wiring — Transmitting electricity to and from the house
  • Service Meter Socket — Housing the service meter and connecting to utility and house wiring

What they say

Hide

I know it's going to spark. I'm going to line up the bottom. All right. Talk about putting the mirror in, Dad. All right. Well, first off, I just took some duct tape because it's an older jacket. It started to peel a little bit, but I can't get into the basement to replace it. So, I don't want you to think that we would leave duct tape on a wire. The wire is in great shape. You never want to put this in until you're bugged in. Why? Because this actually is a load right here. That meter, it is. So, if

Auto-generated from the video audio.