So thats how its done. #tools #diy #construction #mechanic #repair #shorts

All right, what are we looking at with this one now? Tools to make hose clamps out of wire so you always have the right size hose clamp. 10 times stronger, 90% lighter, and low profile. Not cut cutting your hands all up. Stainless wire, let's make a loop. You're going to feed those together like that. Feed your end through your loop, pull it tight. One time around header wrap, exhaust wrap, no pressure. Two times, fuel, air, water, hydraulics, high side AC even. Make sure you're not crossed or not overlapped. That would be your weak spot. Take the tool, slide your nose in. You got a pin and a pin. Over those two and around. Quick twist, locks you down. Notch on the end, pop it in there, and you're in business. Tighten it up. No twisting, you're push pulling. When you're tight, you'll feel it. Go with the flow, you'll feel the tension in the tool. You're going to get nice and flush on your hose, okay? When you're finished, flip that over 180° to lock you in. Back that off. About a quarter of an inch is all you need. Once you press those down, locks you in permanently. That's your brand new hose clamp. Won't vibrate loose, won't come off. To remove our clamp, you bend the tabs over just like this and pull and it releases right back off. Where do you guys find this at? clamptitetools.com clamptitetools.com. Thank you, sir.