Sprayer Tip Selection and Pressure Setting

because we want a weatherproof waterproof the same all the way down to the ground so I'm just going to be using just a fine finish tip low pressure don't need to atomize the product just need to get it on saturate the block so so I don't want to be out of my advising this product not going to be running a high pressure super low pressure I'm just going to be using an hea 311 tip to spray this product on I don't want a lot of overspray it's not windy out here it gets super windy out here at the Bruno sand dunes but today it's calm morning so far the h8 tips supposed to run around 800 to 1100 PSI mask off the metal door jamb over here because we can't get any of this product on that metal door jamb because the metal door jambs could be painted if you get some silicone on a door jambs would be a nightmare to try to paint it we're also going to be