Dedication and Precision in Machining

to finish the job or But it's impossible to do. But you are so interested in making it work that you can do it. Otherwise you wouldn't be able to do it at all. Will there be a water pump? Yes. Oh, yes. There will be a timing cover and a water pump. But there is no water in that block . It's not designed for water, but I'll put a water pump in there anyway, you know . So it looks like what we could do is, we could, you know, cut off half an inch of the block, then bore out the inside, put a plate on top and seal it. But this makes no sense. All we want is to just make it work. Well, if someone gives you a million dollars, you can do anything you want. But there is no need for this . Is this a go-kart piston? This is a stock piston from a Yamaha 125cc scooter . see. So, basically, it is what it is. It's a small, little mini bike. Are you using them in that engine? Mhm. So you just took your calculated cylinder size to half scale and found the closest option that would fit. And this is 54 mm, which was the closest value to half the diameter of the cylinder. Well, and of course, you know, the crankshaft is half the size in every dimension compared to the real thing. But this piston pin hole in the piston is higher than half of a standard piston. So the connecting rod is actually longer, if you measure from center to center, so that the height of the cylinder block fits. I have