Mask Door Edges for Clean Finish

and so it's just dropping pressure extremely fast the door i spray the door we get people asking what about the edges of the door because the door is closed we remove the weather strips and it exposes the two edges right here and i run masking on the door jamb inch and half masking on the door jamb and the edge of the door so it doesn't get overspray on it but the whole face of the door gets sprayed we don't um typically on we do on the front doors we'll remove the hardware but on typically side doors doors like this this is a really old house the hardware is extremely old the customer's not replacing it if you pull the hardware off you might not get it back together properly because it might fall apart so we just mask the door off and then we pull the masking off while it's wet so i'm going to pull it off while it's wet so i don't get any bridging on the door from the tape to the door so i use frog tape to keep any over spray off the door knob or any bleed through off the doorknob so you want to be very careful when pulling your masking off be just patient slow pull it off away from you and pull back and that's how we spray the door that's