Skip to main content
Stesso

Apply and Remove Masking for Door Painting

1:30
4:46
30.9K views

At 1:30 in

Junk airless sprayer! Dino X6 Review. Harbor Freight Airless Paint Sprayer

Watch on YouTube

What happens here

The presenter shifts focus to the practical technique of masking door edges and hardware. For doors that remain closed during painting, weather strips are removed to fully expose the edges, ensuring a complete and even coat. Masking tape (specifically mentioning 1.5-inch Frog Tape) is applied to the door jamb and around the edges of the door itself. The critical advice given is to remove the masking tape while the paint is still wet. This prevents 'bridging,' a common issue where dried paint forms a film between the tape and the painted surface, causing the paint to tear or lift when the tape is removed. Patience and pulling the tape slowly and away from the painted surface are highlighted as essential for clean lines. For very old hardware that might break if removed, masking around it is the safer alternative.

Goal: Learn effective masking strategies for door edges and hardware to prevent overspray, including removing weather strips and carefully pulling tape while the paint is still wet to avoid paint bridging.

Tools and materials

  • Door
  • Masking tape

What they say

Hide

and so it's just dropping pressure extremely fast the door i spray the door we get people asking what about the edges of the door because the door is closed we remove the weather strips and it exposes the two edges right here and i run masking on the door jamb inch and half masking on the door jamb and the edge of the door so it doesn't get overspray on it but the whole face of the door gets sprayed we don't um typically on we do on the front doors we'll remove the hardware but on typically side doors doors like this this is a really old house the hardware is extremely old the customer's not replacing it if you pull the hardware off you might not get it back together properly because it might fall apart so we just mask the door off and then we pull the masking off while it's wet so i'm going to pull it off while it's wet so i don't get any bridging on the door from the tape to the door so i use frog tape to keep any over spray off the door knob or any bleed through off the doorknob so you want to be very careful when pulling your masking off be just patient slow pull it off away from you and pull back and that's how we spray the door that's what it looked like using a dp airless the gun itself really small gun

Auto-generated from the video audio.