Set Up Test and Begin Driving

What happens here

Prepare the testing surface by securing a wooden board, in this case, a 2x4, onto a stable workbench or surface. Mark equidistant lines along the board to ensure consistent placement for multiple lag bolts. Position two different sized lag bolts in pre-drilled pilot holes along these lines. Attach fully charged 18V batteries to both the Makita and Bosch impact drivers. Simultaneously, or as close as possible, begin driving the lag bolts into the wooden board using each impact driver. Observe the initial progress. The Bosch impact driver's specifications are mentioned: model GDR 18V-1800, max IPM of 4000, and max torque of 1800 inch-pounds.

Goal: Initiate the comparative lag bolt driving test.