Disassemble Lawnmower Front Wheels

crap when you got done so we're gonna use these little wimpy jack stands we'll take our jack get our mower up off the ground here slide in our jack stands we need to do a little manual manipulation here there we go pop that dude loose that suckers in there I'm gonna have to get him a rubber hammer and tap on it a little bit always be careful if you're hammering on some bolts or something like that that you don't damage the threads if you're gonna hammer on them so we're gonna get the rubber deadblow hammer to knock this thing out with deadblow every guy needs a dead blow hammer in his toolbox I'll post links to all the tools that I'm using down below in the video description if you see something in here that you're thinking about getting there'll be a link down below if you think you need it it's down there man pain in the butt put the wrench on it come on out of there buddy nothing's ever easy I will now deploy the beater screwdriver everybody needs a good beater screwdriver nothing ever goes like it should so this thing should have just slid right out it's rusty it's been outsides head grass on it grass is really acidic and grass is really really hard on metal so when I get done with my mower I normally try to blow it off the best I can I'll take the leaf blower and blow it off and then once every couple weeks I'll take the air hose and blow it off try to get all that old grass off there especially wet grass don't use a water hose just blow it off Buster out of here come on Buster come on out of there good lord you're making me look bad I'm gonna knock it back and forth a couple times see if that makes it slide out a little easier of course it doesn't good gracious I'm gonna have to use the feet there we go that's what daddy likes there we go see all that crusty rustiness we'll clean that up before we put it back on all right so here's our wheel entire assembly has two little grease caps on the ends right here that one and that one and those cover up the bearings we'll set those to the side and we'll look at our bearings our wheel bearings in here and make sure they're turning free you can tell here this one really isn't turning that free this one yeah they're both kind of gummed up my inclination is to clean them up really good take the air hose and clean them up really good maybe put a little bit of oil in there what I did not know is there is a metal shim down in there