Skip to main content
Stesso

Apply Faux Stone Veneer

22:04
39:52
209.1K views

At 22:04 in

How To Transform an old Fireplace On a Budget

Watch on YouTube

What happens here

Begin by laying out all the faux stone veneer pieces (Creative Mines Craft Masonry Veneer in Wildflower color) to plan the pattern and ensure proper fit. Mix N-type mortar to a consistency slightly thinner than peanut butter. Apply a generous layer of mortar to the back of each stone veneer piece (back-buttering method) and press it firmly onto the cement board, starting with corner pieces to create clean edges. Use a level to ensure each stone is straight and maintain consistent spacing between pieces for a uniform look. Work in sections, allowing the mortar to set partially before moving to the next area. Note: The video uses an exterior-grade stone veneer, requiring a thicker mortar application (approx. 1 inch thick) and specific application techniques compared to thinner interior veneers.

Goal: This step involves mixing mortar and carefully applying faux stone veneer pieces to the prepared cement board surfaces of the fireplace and hearth, focusing on corner pieces first.

Tools and materials

  • Level
  • Mortar Hoe/Mixer
  • Trowel
  • Wire Brush
  • Faux Stone Veneer
  • N-Type Mortar

What they say

Hide

time one of the first things I'm doing cuz I know I'm going to run into this problem because I made enough mistakes in my time is I want to make sure that all the stones have the right amount of spacing to reach the same elevation so I got a/ inch off the top/ inch off the top here all these stones are different see this one's really thin this one's a little bit thicker this is even thicker so lining them all up making sure that I reach my same destination so that when I come to the top here it's just going to be smooth sailing and we know we love a good set [Music] sail got our S Type mortar here let's ho it [Music] up so the last couple of times I've done uh stone veneer like this this is by the way X exterior stuff there's interior stuff it's a lot thinner and when it's interior stuff you treat it like backsplash you just put your thin set on or tiid hesive and you can work your way up with this kind of stone it's a little bit different story cuz you have to put tar paper than uh the metal galvanized la which is like chicken wire uh and then you do a scratch coat and then you apply your your S Type mortar but this is interior and this is going on already uh cement board so I'm kind of treating this as my scratch coat so that's where the adhesion is going to happen I'm applying it the same way I apply to exteriorly you got to put like about an inch thick scrape the edges press it in get all the water out except for I'm back buttering this section just to make sure none of that moisture gets escaped so I get kind of double coverage I don't know if I'm wrong 100% I'm probably 90% sure this is the way to do it um but I know I got professional masonry guys that follow me so I'd love to hear comment down below let me know is this the appropriate way to apply it using exterior veneer uh and uh and if it's not be nice [Music] gosh that makes me happy this is beautiful now I am having troubles with this because when I did my fireplace outside if you haven't seen my video from last summer the stone that I picked was actually really convenient because it had all these little patterns but they all came in the same exact 5- in Grid so you can just start slapping them you can't slap these because they are all different sizes there's probably I want to say five different sizes and they'll vary within like a/4 inch of each other so that's the frustrating part cuz you're keeping going back into your big pallet of stone try to find the match bring it back here that's…

Auto-generated from the video audio.