Skip to main content

Inspect and Finalize the Corrected Trim

5:55
8:42
91.6K views

At 5:55 in

How to Fix Bad Cut-Ins | Pro Technique to Repair Uneven Paint Lines Like a Master Painter

What happens here

After removing the tape, inspect the painted line. If any minor paint bleed-through or drips are observed, they can be corrected later. For small bleed-through spots, a razor blade can be used once the paint is dry to carefully scrape it off. The presenter emphasizes that painting over caulk is beneficial because unpainted caulk tends to gather dirt and yellow over time, whereas painted caulk will maintain its appearance much longer. This technique significantly improves the aesthetic and longevity of the trim.

Goal: Examine the newly painted trim for any minor flaws and understand the long-term benefits of painting over caulk.

Tools and materials

  • Razor blade

What they say

Hide

as much but there we go got one spot whether where it bled through it probably didn't push down on my tape good enough but that is a nice laser straight line it's covered the caulking and one of the things about the exposed caulking the exposed caulking that was here that's not painted just gathers dirt and dust over time gets dirty starts to yellow so now all the caulking is completely painted and it won't yellow and this will dry and look a lot better now got a few drips we've got to correct up here carefully so now this is the frogtape blue so this is uh the same as the frogtape green except it's a contractor packed so it comes in four packs has the same polymer that swells up on the edge of the tape like green but it's just less expensive because it's in contractor packs and doesn't have as high quality of paper as the green tape so it's a great tape i was going to use clear caulking if i needed to uh caulk on a bumpy surface because that's just going to ensure that you're going to get a laser straight line with your call with your frog tape so there we go we corrected that problem i think it looks a lot better myself it'll even look a lot better once it dries if you get any bleeding through anywhere you can go back and correct it after it's completely dry i would just take a razor blade there's one little spot i had some bleeding on it and i'll correct that with a razor blade and fix that this is a simple little method i use this a lot on windows i use this method on ceilings when people have got the wall color onto the ceiling you know significantly you can just side go back and take your cut in or tape and make an edge onto the ceiling a little bit more and you know you can correct the problem hopefully you've enjoyed this simple little tip correcting mistakes that were made from previous people if you liked the video give us a thumbs up don't forget hit the subscribe button hit the notification bell that way you'll get notified every time we come out with a new video if you've got any questions or comments about this technique that i use just leave it down in the comment section below and i'll try to answer your comments or questions as soon as i can subscribe notification bell

Auto-generated from the video audio.