Inspect and Apply Additional Coats (If Needed)

finish, but this will level out very very nice. I'm going to I look at it. It looks like it's covered. You'll 100% whether you think it needs two coats, one coat, two coats, you can, you know, do another pass over it after it dries. It'll be dry in about an hour. Do another pass on it and then pull the masking and you're good to go. But it looks like it's covered 100%. To me, it looks pretty dang good. I got a nice even finish across the whole board. What I'm looking for right here across the whole door. I'm looking for anything that doesn't match up. Is it have the same finish across the whole door? Or is there something then that looks like light? What I would say like kind of a dry feather because I went too fast or I didn't overlap 50%. I looked at it. I can't tell from this lighting. I have to get over into this lighting to actually see it cuz I get a reflection and glare coming through the window. I can see it 100% from top to bottom. It has the exact same uh finish from top to bottom. It's good to go and it's going to dry out and look awesome. So, there it is. how I go about spraying a difficult uh door on the exterior of a new