Install Gas Line and Burner

we're just gonna let it sit overnight talking gas fittings here so this is the part that goes to the grill section i never know how to do this when people go if it's brass you don't need to put anything on there but i was also taught that you could also be safe than sorry um and i by putting just a little bit of tape is not gonna do you any harm so i'm gonna air on the safe side nope this is for the jet sorry yeah keep in mind this one has a direction of the gas flow so you'll know where it goes no i was right i was right i was right that's where it goes ah okay all of our plumbing is all rated against oh we're gonna take this shutoff valve set it into that hole that we created and then use little of these galvanized steel brackets to hold up plumbing and then secure it in place we're then going to thread this on the outside that's like a nice fancy flange also keeps it tight i don't know if you notice but it's sitting on three-quarter inch pieces of wood just so it's not pressing down on the rug and you know air can flow through and then at the same time we're finally going to throw some teflon tape on top of the burner screw this on bring the table top over and that should be ready to go and of course we have to still wet sanded that will be the finishing touches big things are happening [Music] so one problems i'm encountering is that this won't thread um on the inside of that there's obviously transition piece there because if you look inside uh it's kind of flared out and i think there's a piece that i'm missing in the background there it is change of plans i don't want this cable or hose to get compromised so i'm going to put a hole right here and then i'll feed the cable from the inside out just peace of mind