Monitor Pot Life and Plan Cleanup

slowly stir it in. The catalyst doesn't you don't have to have a sweat time to it like some epoxy, some two part coatings. You have to let it sweat, which means you got to let it set for a certain period of time and activate it. There is no sweat time on this product. As soon as I mix it, I'm ready to go to start spraying it. I do have a pot life. You need to pay attention to that pot life because you could ruin your sprayer. If you don't clean it out, you'll be for it hardens because it will harden inside your sprayer. So my pot life is going to be five hours. Once I'm done catalyzing it, stirring it in, I'm going to have Luke mark down our time that we catalyze it and our time we need to clean. That's very important to pay attention to. It's good if you have a phone just a set in the alarm about 30 minutes before, you know, it's time to clean it up. So it's a reminder that the pot life will change according to the conditions room conditions or outside conditions. If it's wherever you're spraying it's really hot. It's going to decrease your pot life. So if it's 95 degrees here inside where I'm at, it's probably going to decrease it down to about four and a half hours. So pay attention to that. So I've got my product mixed up going to