Connect Harness and Pressurize System

to uh install them. And the reason that we go low in the tree, we could actually inject the tree up high here. Uh but trunk wood is meant for vertical movement of water and nutrients. So when water gets to the trunk, it it flows straight up the tree. The reason that we do it down here towards the flare towards the base of the tree is in the flare that's where all the butcher switch come back together and we get lateral distribution. So we want that chemical to remove move around the tree first and then travel up. So that way we know that we're going to get chemical throughout the entire canopy. The way you talk about trees, I'm guessing you live, breathe, and eat trees. Do you dream about trees too, Wes? I dreamt about trees before. [laughter] I think that's how that's how me and you got connected. I watched uh something you had of like a Milwaukee chainsaw. Like you had the first one. Yes. And I watched it and I went to bed and I had a dream that I was running it and I messaged you online like, "Stan, I need that chainsaw." You're [laughter] like, "Yes, you do. Let's check this out." We got them all in all the way around. Just checking to make sure all the valves are closed so that when I pump it up, it doesn't just start blowing it right in there. Okay. So, you pressurize it first. Yep. So, we pressurize it first. Okay. Got to run around the whole system. That's what I was showing at least. Is there a certain amount of pressure you like to pump it up to, Tyler? I usually pump it up to about 50. So, right about there.