Setting Up the Welder and Adjusting Settings

Put that over there, too. So, it does come with drive rollers. Now, they're not in [ __ ] English, so you got to do some different calculations, but you have a 1, which is 40, and then you have a 9, which is 35. You have an eight, which is 30 0, a six, which is 23, and then you have your knurled rollers for uh flux core. You have a 35 and a 3 0 for flux core. So, when I first got this welder, oh [ __ ] a week ago now, probably I [ __ ] ran flux core on it right out the box. And this is I gotta say this is the best welder that I've ran for flux core. It I'll I'll drop some videos of that right now. Just some old flux core I had sitting in there. So, in the box also includes a gas line, but no regulator. So, I just hit up Harbor Freight, picked up a regulator. I have it set at 10 right now. Oh, I got to turn my bottle on. I didn't drain my line last night. I forgot about it and I was too lazy to drain it. Um, I have it set at about 11. You can go up to 12 if you wanted. Um, but yeah, so it comes with a gas line. It doesn't come with a regulator. So, your on switch is right here. Immediately fires up. The fan will run for a minute or so. It's not that annoying. Get this out of the way. [snorts] All right. So, I have my joint set up here. Also, Miller. Check what it is. Looks like it's 3/16. So, I'm going to go to my app here. Mix solid wire steel 316. Give me my settings. So, we're going to go inches per minute, and we're going to go to 3 4 3 21 to 21 to 22 volts. So, let's go with 22 volts and we should be good. So, we got it at