Adjusting the Hub Reamer for 2" Pipe

What happens here

To switch the hub reamer from 1.5-inch to 2-inch, three small screws are removed using a smaller Allen wrench, detaching the inner plate. Then, a larger Allen wrench is used to loosen two set screws, allowing the key to slide from the inner groove to the outer groove, extending the cutting radius. The original screws are then replaced to secure the key in the 2-inch position, and the top plate is reattached. This prepares the tool for larger pipe sizes.

Goal: Convert the hub reamer from 1.5" to 2" pipe size.