Skip to main content

Connect Water and Gas Lines — Connect Water Lines

Intermediate2 mins

Part of project

Water Heater Installation · Step 7 of 13

Helpful?

In this video

Hand-thread the new flexible water lines onto the hot and cold water nipples on top of the heater and to the corresponding pipes on the wall. Then, use pipe wrenches to tighten them until they are snug. The built-in rubber gaskets will create the seal. Next, connect the new flexible gas line to the gas shut-off valve and the port on the heater's gas control unit. Tighten these connections securely.

746.7K views3.1K

FAQs

Do I need specialized tools beyond basic plumbing gear for this project, and which ones are essential?

Yes, beyond basic wrenches and screwdrivers, you'll need large pipe wrenches (like the TradesPro 14 in. HD Pipe Wrench) for stubborn connections. A hand truck (like the Milwaukee 800 lbs. D-Handle Hand Truck) is crucial for safely moving heavy old and new units. For gas heaters, a gas leak detector or a soap solution for testing connections is also essential.

How much time should I realistically budget for a DIY water heater replacement, and is 'intermediate' difficulty accurate?

Budget at least a full day, and potentially two, as stated, especially if you encounter unexpected issues like corroded pipes or need to make trips for additional parts. The 'intermediate' difficulty is accurate because it combines plumbing, potential gas or electrical work, heavy lifting, and strict adherence to safety and code requirements, making it more complex than basic household repairs.

Transcript
Hide

Now, these new copper lines here that I'm putting on are they have a rubber gasket in them, so you really don't need to put any kind of thread compound on this. You just tighten it up, it's real similar to a water hose, there's a rubber gasket in there, so you just tighten it up a little bit snug, and then of course you want to pressure test it and look at all your fittings to make sure there's no leaks, if there is you may have to tighten them a little bit more. You don't want to bend these too abruptly in any given direction like a quick 90, otherwise you get kink it, so you want to be careful to keep full flow through these without kinking the pipe. And once you get all your pipes hooked up, you can want to pressure test it and check all your fittings for leaks. In this case I actually turn the water to the house off at the water meter in the street. I typically don't really mess with the valves going into the house, sometimes they can fail on you, or they may have been there for many years and soon as you start turning them, you end up creating another problem. So if you go out to the street, the valves on the meter are usually pretty good, so you can work those valves without the risk of causing more problems. So there's your whole setup.

Auto-generated transcript. May contain errors.